Site Navigation

Your Account

Choose Language

Help

Range

Yes


Time Estimate

Select a difficulty level for this entire task (including any prerequisite instructions). The difficulty ranking reflects the experience, physical dexterity, and risk involved.

Very easy

Does not require opening device.

Easy

Requires minimal disassembly and requires only basic tools like a Phillips or flat-head screwdriver.

Moderate

Requires a fair amount of disassembly. This is a task that most people would not perform without instruction.

Difficult

Requires significant disassembly and may require specialized tasks like soldering.

Very difficult

This task is considered quite challenging, may require specialized tasks like micro-soldering, and may risk damage to the device. If you can do this, people may call you MacGyver on occasion.

If your guide picks up where an existing guide leaves off, add the existing guide as a prerequisite to avoid having to write additional steps. Prerequisite guides will be displayed before this guide. Make sure that the prerequisite guides are in the correct order. You can change the prerequisite order by dragging the icons to the left of the guide's name.

  • 1 × small screwdriver
  • 1 × small Philip head screwdriver
  • 1 × Metric Allen wrench setball head recommended: https://www.ultibots.com/hex-ball-head-set/
  • 1 × 7mm wrench
  • 1 × 8mm wrench
  • 1 × 10mm wrench
  • 1 × Needle nose pliers
  • 1 × Wire cutters
  • 1 × X-acto or hobby knife
  • 1 × Metric drill bit set
  • 1 × electric drill or pin vise
  • 1 × Soldering iron and solder
  • 1 × metric ruler or calipers
  • 1 × Sharpie™ marker
  • 1 × 3 4" masking tape
  • 1 × 2.5m (8') of 6mm (1 4") rope or suitable strap clamp
  • 1 × Crimping tool (highly recommended)
  • 1 × 10mm socket (optional)
  • 1 × medium or large binding clip (optional)
  • 1 × D300VS 3D Printer Kit
Add New

Your contributions are licensed under the open source Creative Commons license.