Insert an M3 nut in the three belt tensioners as shown in the first photo.
The nut should be oriented away from the top of the carriage. The first photo shows the correct orientation.
Slide the tensioner into the dovetail slot at the top of the carriage.
Insert an M3x20 SHCS into the hole between the ball studs. Use an Allen wrench to start the screw into the captive nut in the tensioner. Only thread on one or two turns.
Complete assembly of all three carriages as shown in the third photo.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.