Locate the three eccentric spacers. Mark the surface closest to the offset hole with a black marker as shown in the first photo. It may also already have text on it.
Press one of the eccentric spacers into the back side of the carriage in the side with the single hole. The black marked surface should face out as shown in the photo.
Insert three M5x35mm axels into each carriage as shown in the second photo.
Add one short 3mm spacer on the axle with the eccentric spacer. Refer to the second photo.
Add one long 9 mm spacer to each of the other two axles.
Repeat installing the eccentrics, axles and spacers on the other two carriages.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.