Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 8 —

Step Type:

Drag to rearrange

Find the parts labelled D300VS-Plus Parts Fan Duct and the printed air duct.

Locate the two rectangular holes on the side near the extruder gear. Insert 2 M3 Jam Nuts. (photo 1)

If the nuts don't fit, you may need to widen the hole using a x-acto knife or small flat-head screwdriver.

Insert a M3 Jam Nut in the topmost hole of the printed air duct. Then insert the M3X8 bolt into the next hole down. (photo 2)

Attach the fan duct to the extruder body matching the topmost round hole (photo 1) with the M3x8 bolt from the previous step. Attach the fan using the M3x18 (top) and then the M3x25 (bottom).

Your contributions are licensed under the open source Creative Commons license.