Do not ream the holes for the mag balls in the effector. They are designed to be a tight fit in order to maintain alignment.
Install six M3 nuts into the six nut traps on the bottom of the effector.
Use an M3x16mm SHCS to draw and seat the nuts fully into the nut traps as shown in first and second photos.
Screw the Mag Balls on finger tight.
Carefully tighten the Mag Balls with a 1/4 turn using a 10mm wrench or socket. Do not over tighten or you may strip the threads.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.