Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 9 —

Step Type:

Drag to rearrange

Ream the two bearing screw holes in the extruder body with a 4mm drill.

Ream the bearing screw hole in the idler with a 4mm drill as shown in the second photo.

Carefully look over both the extruder body and the idler and trim off and clean up any plastic remnants.

Make sure the E3D extruder recess (shown in third photo) does not have any plastic remnants or burrs.

Your contributions are licensed under the open source Creative Commons license.