Bottom Frame - there is a step to add 3 t-nuts to top slot of X rail. add an extra one to have 3 on Z too. This is because the wire whip might go to the right depending on how you like to orientate The Aero Titan or maybe want to mount a lamp or camera on the other.
Tower height is different, don't cut T-slot covers at the time of endstop wiring. do it later (TBD)
after installing LED wiring, you might want to add tape or dull the sharp edge where wire comes down out of vertical extrusion. I believe over time it will cut through the insulation shorting it.
Install the top on the towers FLUSH, because the belt tensioning is done on the carriage now.
If you plan on mounting the Paneldue, add 2 t-slot nuts to the slot facing up on the Y assembly of the top cross frame member (Steps 18 & 19).
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.