Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Now you are going to neaten up the wiring. This is a lot easier to visualize and do than to describe so please look at the photos closely.

Start by routing the Z stepper motor wires underneath the Duet and towards the front of the printer. Once routed, fasten the X, Y and Z stepper wires with a small Zip Tie as shown with the purple arrow nearest the Duet.

Bundle the X and Y stepper motor wires and fasten with a second small Zip Tie as indicated by the purple arrow.

Route the Z stepper motor wires underneath the JohnSL mounting arm towards the right (Y tower) as shown in the photo. The photo shows an "X-Ray" view of these wires underneath the mount. Secure the wires with two large Zip Ties on the FSR mounting arm as indicated with the blue arrows.

A third large Zip Tie secures the Z stepper motor wires and the Y endstop wires as indicated with the blue circle.

Route the Z and X endstop wires and the LED wires to the left (X tower) and secure to the top of the Duet mounting arm with two large Zip Ties as indicated by the blue arrows.

Your contributions are licensed under the open source Creative Commons license.