Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 40 —

Step Type:

Drag to rearrange

Flip the entire printer upside down so the top is sitting on your table with the Z tower to your right.

This may seem odd but it is a lot easier than soldering standing on your head.

Strip 2mm (1/8") of insulation from the ends of the red and black LED wires, tin and solder them to the tinned terminals.

Make sure to solder the red wire to the positive (+) terminal pad.

Cover the terminal pads with two strips of Kapton tape.

Your contributions are licensed under the open source Creative Commons license.