Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 31 —

Step Type:

Drag to rearrange

Pull the endstop wires out of the bottom of the tower extrusion until the other end (white connectors) are about 40mm (1.5") shorter than the tower length as shown in the photo.

Insert one of the plastic T-slot covers you removed from the tower slots earlier. Slide the end about 2cms (1") into the corner extrusion.

Continue installing the T-slot cover in the slot until you reach near the top. Cut the T-slot cover 60mm (2-3/8") from the end of the tower as shown.

Install the endstop wires in the Y tower and install the T-slot cover in the same way.

Install the endstop wires in the Z tower but do not install the T-slot cover.

Your contributions are licensed under the open source Creative Commons license.