Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 54 —

Step Type:

Drag to rearrange

Turn the D300VS upside down with the X tower to your right, the Y to your left and the Z tower in the rear.

The endstop wires will be routed in the slots at the bottom of the lowest base cross members. This is easiest if you place the printer on the floor.

Cut three pieces of T-slot cover about ~180mm (7") long.

Start with the Z endstop and LED wires. Route both pairs of wires down the right base cross member towards the X tower. Hold the wires in place with a piece of T-slot cover as shown in the first photo. The wires should exit the slot between the Duet mounting arms as shown.

Route the Y endstop wires (on your left) from the Y tower towards the Z tower. Cover with a piece of T-slot cover.

Route the X endstop wires (on your right) from the X tower towards the Z tower. Cover with a piece of T-slot cover.

Your contributions are licensed under the open source Creative Commons license.