Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 56 —

Step Type:

Drag to rearrange

The connectors on the stepper motor wiring harness have two ridges on one side. We've highlighted those with black marker in the first photo. Use an X-acto knife to trim them off of the X, Y and Z stepper connectors. Don't worry about routing the stepper harnesses neatly at this point, we'll do that later.

Connect the stepper motors to the Duet as shown in the second photo.

Start with the Z stepper motor, then the Y and finally the X.

Make sure to orient the wires as shown with the blue wire on the right side of the connector.

Check your connections to the Duet to make sure the X, Y and Z steppers are connected to the correct positions as shown in the second photo.

Your contributions are licensed under the open source Creative Commons license.