Skip to main content

Site Navigation

Your Account

Choose Language


Step Type:

Drag to rearrange

Orient the stepper and corner assemblies as shown. Label them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on the bottom for all three assemblies.

Locate the six square frame extrusions. Attach two of these on the right side of each corner assembly as shown in the photo.

The trick to working with T-nuts is to orient them with the slot before attempting assembly. I also find that moving the slotted extrusion while keeping the part with the T-nuts stationary works best.

Snug but do not tighten the screws.

Your contributions are licensed under the open source Creative Commons license.