Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 15 —

Step Type:

Drag to rearrange

Push all three of the cross members closest to the table flat against the table. Then tighten the six screws closest to the table as shown in the photo.

Remove the cord and carefully flip the base unit over.

Push the three cross members nearest the table flat against the table and tighten the six screws as you did in the first step.

Now tighten the six screws you can reach nearest you located inside the corner brackets as shown in the second photo.

A ball head Allen wrench is very helpful to reach these screws.

Once again, flip the base unit over. Tighten the remaining six screws you can reach inside the corner brackets.

Make sure all twenty-four screws are tight.

Lay the base on the flat surface with the XYZ labels facing up and test to see if it rocks or tips. If so, you need to loosen all of the screws and repeat this step again! So best to work carefully and get it right the first time.

Your contributions are licensed under the open source Creative Commons license.