Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 3 —

Step Type:

Drag to rearrange

Install the two M3 nuts into the carriage slots. This can be tricky but you can align the nut and then push it in with a small screwdriver.

Once the nut is in place, use a 2mm Allen wrench to make sure the nut is aligned with the hole in the carriage.

Install only the magball on the left side of the carriage as shown. A 10mm socket works well or use a 10mm wrench. Tighten but do not over-tighten the magball.

Your contributions are licensed under the open source Creative Commons license.