Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Gather the parts for this step.

Three base corner brackets are the larger set of brackets (box B). The smaller set are the top corner brackets.

Three stepper motors from box C.

Remove the following parts from the bag labeled Motion MagBall in box C. The parts are listed on the bag label.

Twelve M3x8 SHCS - Motors.

Three GT2 16 Tooth Pulleys.

Loosely attach a pulley to each of the stepper motor shafts using a 1.5mm Allen wrench. The thin flange should face away from the stepper as shown in the photo. One of the two set screws should align with the flat on the stepper motor shaft as shown.

Orient the wiring coming out of the stepper to face up as shown and attach to the corner bracket using four M3x8 SHCS screws for each assembly. Use a 2.5mm Allen wrench, a ball head Allen wrench makes this a lot easier.

Your contributions are licensed under the open source Creative Commons license.