Skip to main content

Site Navigation

Your Account

Choose Language


Step Type:

Drag to rearrange

The top assembly must be installed with the labels you applied facing up and the X, Y and Z corners aligned with the base X, Y and Z corners.

The idler pulley holes in the top brackets must be closest to the bottom of the frame as indicated in the photo.

Align the T-nuts and carefully lower the top assembly onto the towers. "Wiggle and jiggle" the T-nuts until the top assembly slides over both T-nuts in each corner bracket.

It helps to have a helper with this step but it can be done alone if you align the T-nuts and work slowly.

The third photo is annotated to show the conventional orientation for delta printers. The X tower is to the left, Y to the right and Z in the center back.

Your contributions are licensed under the open source Creative Commons license.