Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Positon the base with the X, Y, Z labels facing up on a flat surface.

Align the T-nuts in the X corner bracket so the tower extrusion slot can slide onto them.

The end of the tower with the tape-marked threaded hole inserts into the base. The threaded hole should be on the outside edge of the base bracket as shown in the photo.

Slide the tower extrusion over the T-nuts. Push the tower all the way down to the table. Then tighten the two screws.

Remove the masking tape marking the threaded hole before inserting the tower in its slot.

Repeat the previous steps for the Y and Z towers.

Your contributions are licensed under the open source Creative Commons license.