Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Eric Santiago

Edit approved by Eric Santiago

Deleted
Added
Unchanged

Step Lines

[title] Build the Wheels
[* icon_note] Repeat these steps to build all 9 wheels.
[* black] Locate the individual bagged parts for the wheels. Each contains 1 wheel, 2 bearings, 2 washers, and 1 lock nut.
[* black] On a flat surface, press one of the bearings into the face of the wheel until it is flush. (photo 1)
[* black] Turn over the wheel. Drop a washer into the center of the wheel aligned with the center hole. (photo 2)
[* black] Press the second bearing into the face of the wheel until it is flush. (photo 3)
[* black] Set aside the completed wheel and lock nut for later steps. The second washer is not used.
[* icon_caution] Be sure to place a washer between the two bearings.
[* icon_note] The washer may fall out of alignment with the center hole. This is expected.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added