Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by Eric Santiago

Edit approved by Eric Santiago

Deleted
Added
Unchanged

Step Lines

[title] Installing the Wheels
[* orange] Photo two showsAdd three wheels and lock nuts from step 2.
[* icon_note] If the washer between the bearings moves off center and you can't get the axel through, just use a pen tip or small screwdriver to push it back in place.
[* black] Tighten the nut with an 8mm wrench and 3mm Allen wrench.
[* icon_note] Make sure
the completed wheel assemblycan spin without being loose or so tight that the bearings feel like they are grinding.
[* orange] The assembly ordericon_reminder] Confirm the black mark on the axle is:offset spacer (9mm or 3mm) | bearing | ''Delrin™ wheel | washer | bearing | lock nut''
[* icon_note] Note that there
is an extra washer incorrectly positioned after you tighten the ''Open Builds wheel ''bag. You will not need this washerlock nut.
[* orange] Repeat for the other 2 carriages
.
[* orange] Photo two showsAdd three wheels and lock nuts from step 2.
[* icon_note] If the washer between the bearings moves off center and you can't get the axel through, just use a pen tip or small screwdriver to push it back in place.
[* black] Tighten the nut with an 8mm wrench and 3mm Allen wrench.
[* icon_note] Make sure
the completed wheel assemblycan spin without being loose or so tight that the bearings feel like they are grinding.
[* orange] The assembly ordericon_reminder] Confirm the black mark on the axle is:offset spacer (9mm or 3mm) | bearing | ''Delrin™ wheel | washer | bearing | lock nut''
[* icon_note] Note that there
is an extra washer incorrectly positioned after you tighten the ''Open Builds wheel ''bag. You will not need this washerlock nut.
[* orange] Repeat for the other 2 carriages
.