Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Eric Santiago

Edit approved by Eric Santiago

Deleted
Added
Unchanged

Step Lines

[title] Install the cooling fan
[* black] Find the parts labelled ''D300VS-Plus Parts Fan Duct'' and the printed air duct.
[* black] Locate the two rectangular holes on the side near the extruder gear. Insert 2 ''M3 Jam Nuts''. (photo 1)
[* icon_note] If the nuts don't fit, you may need to widen the hole using a x-acto knife or small flat-head screwdriver.
[* black] Insert a M3 Jam Nut in the topmost hole of the printed air duct. Then insert the M3X8 bolt into the next hole down. (photo 2)
[* black] Attach the fan duct to the extruder body matching the topmost round hole (photo 1) with the M3x8 bolt from the previous step. Attach the fan using the M3x18 (top) and then the M3x25 (bottom).

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added