Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #28

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install the Heat Exchanger
[* icon_note] A piece of special thermally conducting tape called ''Akaska Heat Tape'' found in the ''Micro Extruder Motor'' bag is used to attach the heat sink to the motor
[* red] Remove the paper protective film from the ''Akaska Heat Tape'' and apply the tape to the inside of the ''heat sink''. Trim the excess tape off with an X-acto knife.
[* red] Remove the pink plastic film from the tape and snap the heat sink around the ''extruder stepper motor'' oriented down as shown in the second photo.
[* red] The third photo shows a side view of the completed extruder and hot end assembly.
[* icon_note] That completes the effector, extruder and hot end assembly. Please read the notes and tips on the D300VS Build Guide ''Step 63'' before continuing with your build.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added