Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #26

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assembling Extruder and Hot End
[* red] Insert the hot end into the recess in the extruder as shown in the first photo. Note the red arrow -showing the hot end must befully inserted far enough into the extruder so theextruder. The screws that attach the ''part cooling fan bracket'' will fit through the groove in the hot endend so it must not be showing.
[* red] Insert the hot end into the recess in the extruder as shown in the first photo. Note the red arrow -showing the hot end must befully inserted far enough into the extruder so theextruder. The screws that attach the ''part cooling fan bracket'' will fit through the groove in the hot endend so it must not be showing.
[* icon_caution] Make sure the PTFE tube is installed in the hot end.
[* red] Install the ''heat exchanger fan shroud'' with the fan positioned under the ''stepper motor'' as shown in the first photo. Note the blue arrow - it shows the bottom of the ''heat exchanger fan shroud'' aligned with the first fin on the heat exchanger.
[* red] Attach the ''part cooling fan bracket ''to the extruder with two cap screws as shown in the second photoand third photos. These screws '''must''' engage the slotgroove in the top of the hot end.
[* red] Attach the ''part cooling fan bracket ''to the extruder with two cap screws as shown in the second photoand third photos. These screws '''must''' engage the slotgroove in the top of the hot end.
[* red] The third photo shows the part completed assembly.
[* icon_note] Note: you may install the blue silicone sock on the heater block at this time as shown.