Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #25

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assemble Part Cooling Fans
[* red] Trim off the corner pads (used to hold the ''fan bracket'' to the bed when it was printed) with an X-acto knife. Note the circular cutout indicated by the arrow - clean any plastic residue from it too.
[* red] Install a ''part fan'' to the ''fan bracket'' using two cap screws as shown in the second photo.The round part of the fan will fit into the circular cutout in the ''fan bracket''. Note that the label must face out with the opening directed away from the bracket as shown.
[* icon_caution] These screws are threaded into the plastic so do not over tighten them or you will strip the ''fan bracket'' threads.
[* red] Install the second ''part fan'' as shown in the third photo. Its latelabel will face inward.
[* red] Install the second ''part fan'' as shown in the third photo. Its latelabel will face inward.