Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #23

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install Thermistor and Heater Cartridge
[* red] Install the thermistor cartridge in the heater block. The wires should protrude from the side shown in the first photo. The set screw and small Allen wrench are included in the E3D V6 hot end kit. ++Tighten the set screw until it just touches the cartridge then do one more 1/2 turn++'''bold text'''.
[* icon_caution] Do not over-tighten the set screw, you will damage the thermistor.
[* red] Install the cartridge heater with its wires coming out the same side. Align the wires as shown in the second photo. Tighten the clamp with an M3x10 screw until the cartridge is held securely in place.
[* red] Clip the thermistor lead wires to the thermistor connector as shown in the third photo.

Image 1

No previous image

Added

Image 2

No previous image

Added