Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #22

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Trial Fit the Hot End
[* icon_note] Make sure the black plastic collar is not installed on the heatsink (circled in the first photo). You will not use this piece.
[* red] Test fit the heatsink into the extruder as shown. It should be a snug fitfriction fit but '''should not''' take extreme force. Use an X-acto knife to remove any burrs or plastic fragments if it does not fit easily.
[* icon_caution] Be careful not to bend the heat break by using too much force. Do not put pressure on the heat block, only the heat exchanger.
[* red] Remove the hot end after insuring a good
fit.
[* red] Test fit the heatsink into the extruder as shown. It should be a snug fitfriction fit but '''should not''' take extreme force. Use an X-acto knife to remove any burrs or plastic fragments if it does not fit easily.
[* icon_caution] Be careful not to bend the heat break by using too much force. Do not put pressure on the heat block, only the heat exchanger.
[* red] Remove the hot end after insuring a good
fit.