Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #21

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install Heat Exchanger
[* red] Apply a thin coating of heatsink compound to the heat break threads. Do not get the compound on the unthreaded area. A little goes a long way.
[* icon_note] Save the remaining compound for later, you will use it when installing the heated bed.
[* red] Install the heatsink and hand tighten it to the heat break as shown in the second photo.
[* icon_caution] Note that the heatsink must not be tightened against the heater block. There should be about a 3mm gap between these parts as shown.

Image 1

No previous image

Added

Image 2

No previous image

Added