Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Removing the Supports
[* red] Remove the two supports highlighted in red from the ''extruder body'' using a sharp X-acto knife. Remove the single highlighted support from the ''idler''.
[* red] Clean up the openings as shown in the second photo.
[* red] Next clean out the four holes on the ''extruder body'' and the support on the back side of the ''idler'' as shown in the third photo.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added