Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #72

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Finishinginstalling the whip
[* black] Insert wisdom herered] Smooth the braided sheath down from the effector to the ends of the wire. This is very much like petting a snake from its head to tail. Make sure that the braid is taught around the wires.
[* red] Slide the remaining piece of ''1/2" heat shrink'' onto the whip about 1/2 way up.
[* red] Measure 825mm (32.5") from the top of the wire management mount on the effector as shown in the first photo. Then carefully cut the braid with a pair of sharp pointed scissors and remove the excess.
[* red] Slide the end of the whip over the wire mast, making sure the mast is inside the braided sleeve. Secure the wires immediately below the end of the whip with two small ''Zip Ties'' as shown in the second photo.
[* icon_note] The extension splices should all be slightly below the ''Zip Ties'' and mount as shown.
[* red] Slide the het shrink tubing down to the mast mount and carefully shrink it to secure the whip.
[* icon_caution] Be careful not to apply too much heat and melt the braided sheath
.
[title] Finishinginstalling the whip
[* black] Insert wisdom herered] Smooth the braided sheath down from the effector to the ends of the wire. This is very much like petting a snake from its head to tail. Make sure that the braid is taught around the wires.
[* red] Slide the remaining piece of ''1/2" heat shrink'' onto the whip about 1/2 way up.
[* red] Measure 825mm (32.5") from the top of the wire management mount on the effector as shown in the first photo. Then carefully cut the braid with a pair of sharp pointed scissors and remove the excess.
[* red] Slide the end of the whip over the wire mast, making sure the mast is inside the braided sleeve. Secure the wires immediately below the end of the whip with two small ''Zip Ties'' as shown in the second photo.
[* icon_note] The extension splices should all be slightly below the ''Zip Ties'' and mount as shown.
[* red] Slide the het shrink tubing down to the mast mount and carefully shrink it to secure the whip.
[* icon_caution] Be careful not to apply too much heat and melt the braided sheath
.

Image 1

No previous image

Added

Image 2

No previous image

Added