Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #71

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Extend the wiring harness
[* icon_note] The wiring harness - aka ''whip'' - coming from the effector should have four pairs of wires and one set of four wires (from the extruder stepper motor). You will extend all of these wires using the extra wires and heat shrink in the ''Extruder Extensions'' bag.
[* red] Parts cooling fan wire extension: clip off the white connector (should still have a knot near the end too) and strip 8mm (5/16") of insulation from the wire ends.