Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #71

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Extend the wiring harness
[* red] Draw the sheath up over the wires to expose about 150mm (6") of the ends. Secure the sheath with masking tape or a large binder clamp like the one in the photo.
[* red] '''Parts cooling fan wires extension:''' clip off the white connector (should still have a knot near the end too) and strip 8mm (5/16") of insulation from the wire ends. Locate one pair of the ''26/2 Cable Pre-Terminated'' wires and shorten it from the male "pin" end by ....
[* red] '''Hot end cooling fan wires extension:''' clip off the black connector (should still have a knot near the end too) and strip 8mm (5/16") of insulation from the wire ends. Locate one pair of the ''26/2 Cable Pre-Terminated'' wires and shorten it from the male "pin" end by ....
[* red] '''Thermistor wires extension:''' clip off the black connector (there should not be a knot near the end) and strip 8mm (5/16") of insulation from the wire ends. Locate one pair of the ''26/2 Cable Pre-Terminated'' wires and shorten it from the male "pin" end by ....
[* red] '''Cartridge heater wires extension:''' strip 8mm (5/16") of insulation from the wire ends (the larger pair of blue wires). Extend with the pair of red ''18 AWG Silicone Wires'' using the two pieces of ''3/32" Heat Shrink'' to insulate them.
[* red] '''Stepper motor wires extension:''' clip off the white connector and strip 8mm (5/16") of insulation from the four wire ends. Locate two pairs of the ''26/2 Cable Pre-Terminated'' wires and shorten them from the male "pin" end by .... Label one pair '''A''' and the other pair '''B''' near the connectors with marking tape.
[* red] Solder and insulate the each wire as shown in the second photo: black stepper wire to the black wire in the '''A''' pair. Brown stepper wire to the red wire in the '''A''' pair. Yellow stepper wire to the black wire in the '''B''' pair. Orange stepper wire to the red wire in the '''B''' pair.

Image 1

No previous image

Added