Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #67

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install FSRs
[* red] Prepare the three ''FSRs'' by adhering a ''silicone pad'' to the center of the top and bottom of the pad as shown in the first photo.
[* icon_note] The ''FSRs'' do have adhesive protected with brown film on their bottom side but do not use this adhesive. Leave the brown film in place and attach the silicone pad directly to it.
[* red] Install the three ''FSR wiring harnesses'' on the ''FSRs''. Polarity does not matter.
[* red] Insert the ''FSRs'' into their ''mounting blocksthe recesses in the top of the ''bed mounts'' with the right side ("top" in first photo) up as shown in the second photo. Orient the ''FSR'' connector and wires as shown.
[* red] Insert the ''FSRs'' into their ''mounting blocksthe recesses in the top of the ''bed mounts'' with the right side ("top" in first photo) up as shown in the second photo. Orient the ''FSR'' connector and wires as shown.
[* red] Connect the ''FSR'' wires to the ''JohnSL board'' as shown in the second photo. The '''X-Z''' ''FSR'' connects to the left terminal, the '''X-Y''' ''FSR'' connects to the center terminal and the '''Y-Z''' ''FSR'' connects to the right terminal.
[* red] Secure the ''FSR'' wires in the upper cross members using a ~40mm (1.5") piece of ''T-slot cover'' as shown in the second photo. The cut-off pieces of ''T-slot cover'' you saved are perfect for this.