Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #67

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install FSRs
[* red] Prepare the three ''FSRs'' by adhering a ''silicone pad'' to the center of the top and bottom of the pad as shown in the first photo.
[* icon_note] The ''FSRs'' do have adhesive protected with brown film on their bottom side but do not use this adhesive.
[* red] Install the three ''FSR wiring harnesses'' on the ''FSRs''. Polarity does not matter.
[* red] Insert the ''FSRs'' into their ''mounting blocks'' with the right side ("top" in first photo) up as shown in the second photo. Orient the ''FSR'' connector and wires as shown.
[* red] Connect the ''FSR'' wires to the ''JohnSL board'' as shown in the second photo. The '''X-Z''' ''FSR'' connects to the left terminal, the '''X-Y''' ''FSR'' connects to the center terminal and the '''Y-Z''''' FSR'' connects to the right terminal.
[*
red] Secure the ''FSR'' wires in the upper cross membermembers using a ~40mm (1.5") piece of T-slot cover as shown in the second photo.
[* red] Connect the ''FSR'' wires to the ''JohnSL board'' as shown in the second photo. The '''X-Z''' ''FSR'' connects to the left terminal, the '''X-Y''' ''FSR'' connects to the center terminal and the '''Y-Z''''' FSR'' connects to the right terminal.
[*
red] Secure the ''FSR'' wires in the upper cross membermembers using a ~40mm (1.5") piece of T-slot cover as shown in the second photo.