Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #63

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install filament spool holder
[* blackred] Locate the ''left and right filament spool brackets'', the two ''spool cones'', the ''Spool Hardware'' bag and the ''spool axel'' (grey PVC tubing).
[* icon_note] The ''spool axel'' is taped shut at both ends, inside you will find two pieces of wire. These will be used in an upcoming step to install the wiring harness.
[* red] Loosely attach the ''left and right filament spool brackets'' to the ''T-nut''s on the top unit. These are in the cross members coming from the '''Z''' tower as shown in the second photo.
[* red] Install the ''spool cones'' on the ''spool axel'' as shown in the third photo. You may have to enlarge the bore in them to get a tight friction fit on the ''axel''.
[* red
] Insert wisdom herethe ''axel'' into the ''spool brackets'' and slide the ''brackets'' on the cross members so the ''axel'' is supported as shown in the third photo. Then tighten the four screws to secure the ''brackets''.
[* icon_note] Remove the axel and set aside so it is not in your way in upcoming steps
.
[title] Install filament spool holder
[* blackred] Locate the ''left and right filament spool brackets'', the two ''spool cones'', the ''Spool Hardware'' bag and the ''spool axel'' (grey PVC tubing).
[* icon_note] The ''spool axel'' is taped shut at both ends, inside you will find two pieces of wire. These will be used in an upcoming step to install the wiring harness.
[* red] Loosely attach the ''left and right filament spool brackets'' to the ''T-nut''s on the top unit. These are in the cross members coming from the '''Z''' tower as shown in the second photo.
[* red] Install the ''spool cones'' on the ''spool axel'' as shown in the third photo. You may have to enlarge the bore in them to get a tight friction fit on the ''axel''.
[* red
] Insert wisdom herethe ''axel'' into the ''spool brackets'' and slide the ''brackets'' on the cross members so the ''axel'' is supported as shown in the third photo. Then tighten the four screws to secure the ''brackets''.
[* icon_note] Remove the axel and set aside so it is not in your way in upcoming steps
.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added