Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #69

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Prepare the part cooling fan wiring
[* red] Find the two pairs of part cooling fan wires with the white connectors coming from the effector harness. These should have knots tied in their ends to help identify them.
[* red] Clip both wires approximately 125 mm (5") from where thethey emerge at the top of the effector'' Zip Ties'' that hold the wire bundle in place. Discard one of the long pieces, the other will be used to tie the two fans together into one set of lead wires.
[* red] Strip 8mm (3/16") of insulation off the ends of the two short pairs of wires coming from the extruder and the longer piece you kept.
[title] Prepare the part cooling fan wiring
[* red] Find the two pairs of part cooling fan wires with the white connectors coming from the effector harness. These should have knots tied in their ends to help identify them.
[* red] Clip both wires approximately 125 mm (5") from where thethey emerge at the top of the effector'' Zip Ties'' that hold the wire bundle in place. Discard one of the long pieces, the other will be used to tie the two fans together into one set of lead wires.
[* red] Strip 8mm (3/16") of insulation off the ends of the two short pairs of wires coming from the extruder and the longer piece you kept.
[* icon_caution] It is important that you attach all three red wires together and all three black wires together.
[* red] Slip a piece of ''3/32" Heat Shrink'' (from the ''Extruder Extensions'' bag) over the long red wire end and then twist the wires together, solder them and protect with the shrink wrap as shown in the photo.
[* red] Repeat with the set of black wires.