Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #59

Edit by Eric Santiago

Edit approved by Eric Santiago

Deleted
Added
Unchanged

Step Lines

[title] First movement!
[* redicon_note] If your Duet already has RRF 1.19.2 installed you only need to copy the 4 folders from the latest [https://github.com/UltiBots/D300VS/tree/master/Firmware|1.19.2 ZIP] (gcode, macros, sys, www) onto the SD card installed on the Duet and restart/repower the controller. See the [https://duet3d.dozuki.com/Guide/1.%29+Getting+Connected+to+your+Duet/7?lang=en|Duet Guide] for instructions on getting the version and connecting via wifi
[* black
] Once you've validated that your endstops are working properly, click on the '''G-Code Console''' button in the left column. You will see the ''Console'' page shown in the first photo.
[* redicon_note] If your Duet already has RRF 1.19.2 installed you only need to copy the 4 folders from the latest [https://github.com/UltiBots/D300VS/tree/master/Firmware|1.19.2 ZIP] (gcode, macros, sys, www) onto the SD card installed on the Duet and restart/repower the controller. See the [https://duet3d.dozuki.com/Guide/1.%29+Getting+Connected+to+your+Duet/7?lang=en|Duet Guide] for instructions on getting the version and connecting via wifi
[* black
] Once you've validated that your endstops are working properly, click on the '''G-Code Console''' button in the left column. You will see the ''Console'' page shown in the first photo.
[* red] Now for the fun! Enter '''G28''' (with a capital G and no spaces) in the ''Send G-Code... ''field and press '''Send''' or click the '''Return''' key.
[* red] Your printer should ''''home'''' - move the carriages '''UP''' until they hit the endstop switches and stop. ''Homing'' is the most common command you'll use. There is a '''Home All''' button on the ''Machine Control'' page that does the same thing but it's good to learn ''G28''.
[* icon_note] If your carriages move ++DOWN++ instead of up, you have connected your stepper motor wiring incorrectly. You will have to turn off the power supply so be prepared to hit the on/off switch. If your printer homes in the wrong direction, go back and review ''Step 57''.
[* icon_note] If your carriages do move towards the top but do not make it all the way to the endstop switches, enter '''G28''' a second time and they should. This is a little anomaly that won't happen once you install the delta arms and effector.