Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #55

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Connecting endstops
[* red] Locate three ''3-position connectors'' and the pins from the ''Duet Wifi Connectors'' bag.
[* icon_note] Flip the printer back over and on your workbench if you haven't done so already.
[* icon_caution] Do not cut the endstop wires, we will route the wires properly in a later step.
[* red] Strip the ends of the wires and crimp the terminal pins on them. Push the pins into the ++two outer terminal positions++.
[* icon_note] Polarity doesn't matter for these mechanical endstop switch connections. However, the photos do show the preferred connection to ground and signal on the endstop connectors.
[* red] Repeat the above steps to attach the '''Y''' endstop to the '''Y''' connector as shown in the second photo. Note that it is the middle one of the three.
[* red] Repeat the above steps to attach the '''X''' endstop to the '''XX''' connector a s shown in the third photo.
[* red] Repeat the above steps to attach the '''X''' endstop to the '''XX''' connector a s shown in the third photo.
[* icon_caution] Double check to make sure you connected the '''X''' and '''Y''' endstop switches to the the correct terminals as shown in the third photograph.