Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #43

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Finish installing the belts
[* icon_note] It is important for the belt to be evenly spaced from the tower for its entire length. The red highlighted area in the first photo should help visualize what you are trying to achieve.
[* icon_note] You will probably have to adjust the ''pulley'' position on the ''stepper motor'' shaft to align the belt evenly from the tower. If so, the next indented step explains how.
[* red] Loosen the two set screws on the ''pulley'' - you can see the set screws in the second photo. Then move the ''pulley'' on the shaft to bring the ''belt'' into alignment with the tower.
[* red] Tighten both set screws once the belt is properly aligned.
[* red] Repeat '''Steps 41'Steps 42'' to '''43'44'' to install the ''belts'' on the remaining two towers.
[* red] Repeat '''Steps 41'Steps 42'' to '''43'44'' to install the ''belts'' on the remaining two towers.