Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #43

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Finishing off the belts
[* red] Look at the first photo, the ''belt'' should be evenly spaced from the tower its entire length. The red highlight should help you visualize this gap.
[* red]
You will probably have to adjust the ''pulley'' position on the ''stepper motor'' shaft to bring it into alignment.
[* red] Loosen the two set screws on the ''pulley'' - you can see the set screws in the firstsecond photo. Then move the ''pulley'' on the shaft to bring the ''belt'' into alignment with the tower. Tighten the set screws.
[* red] Look at the first photo, the ''belt'' should be evenly spaced from the tower its entire length. The red highlight should help you visualize this gap.
[* red]
You will probably have to adjust the ''pulley'' position on the ''stepper motor'' shaft to bring it into alignment.
[* red] Loosen the two set screws on the ''pulley'' - you can see the set screws in the firstsecond photo. Then move the ''pulley'' on the shaft to bring the ''belt'' into alignment with the tower. Tighten the set screws.
[* red] Repeat '''Steps 41''' to '''43''' to install the ''belts'' on the remaining two towers.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Deleted