Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #40

Edit by Michael Hackney

Edit approved by Michael Hackney


Step Lines

[title] Connect the LEDs
[* red] Flip the entier printer upside down so the top is sitting on your table with the '''Z''' tower to your right.
[* icon_note] This may seem odd but it is a lot easier than soldering standing on your head.
[* red] Strip 2mm (1/8") of insulation from the ends of the red and black ''LED wires'', tin and solder them to the tinned terminals.
[* icon_caution] Make sure to solder the red wire to the positive (+) terminal pad.
[* red] Cover the terminal pads with two strips of Kapton tape.

Image 1

No previous image


Image 2

No previous image