Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Michael Hackney

Edit approved by Michael Hackney


Step Lines

[title] Attaching base frame cross members
[* red] Orient the stepper and corner assemblies as shown. Label them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on top for all three assemblies.
[* red] Locate the six ''square frame extrusions''. Attach two of these on the ++right side++ of each corner assembly as shown in the photo.
[* icon_reminder] The trick to working with T-nuts is to orient them with the slot before attempting assembly. I also find that moving the slotted extrusion while keeping the part with the T-nuts stationary works best.
[* icon_note] Snug but do not tighten the screws.