Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Attaching base frame cross members
[* blackred] Orient the stepper and corner assemblies as shown. Label them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on top for all three assemblies.
[* blackred] Locate the six ''square frame extrusions''. Attach two of these on the ++right side++ of each corner assembly as shown in the photo.
[* black

[* icon_note
] Snug but do not tighten the screws.
[* black] Put a small piece of tape on each stepper opposite the wire side. Label the assemblies X, Y and Z.
[* blackred] Orient the stepper and corner assemblies as shown. Label them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on top for all three assemblies.
[* blackred] Locate the six ''square frame extrusions''. Attach two of these on the ++right side++ of each corner assembly as shown in the photo.
[* black

[* icon_note
] Snug but do not tighten the screws.
[* black] Put a small piece of tape on each stepper opposite the wire side. Label the assemblies X, Y and Z.