Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Attaching base frame cross members
[* black] Orient the stepper and corner assemblies as shown. AttachLabel them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on top for all three assemblies.
[* black] Locate the six ''square frame extrusions''. Attach
two cross members toof these on the right side++right side++ of each corner bracketassembly as shown in the photo.
[* black] Orient the stepper and corner assemblies as shown. AttachLabel them X, Y and Z with a small piece of masking tape. Make sure the wiring harness is on top for all three assemblies.
[* black] Locate the six ''square frame extrusions''. Attach
two cross members toof these on the right side++right side++ of each corner bracketassembly as shown in the photo.
[* black] Snug but do not tighten the screws.
[* black] Put a small piece of tape on each stepper opposite the wire side. Label the assemblies X, Y and Z.

Image 1

Old Version

New Version

Image 2

No previous image

Added