Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #35

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Installing the endstops
[* red] Attach a ''T-nut'' with an ''M5x10 low profile socket head screw'' with the center raised section of the ''T-nut'' facing as shown.
[* red] Install the ''endstop switch bracket ''on the tower with the ''T-nut'' on the right side as you face the ''T-slot cover'' as shown. The top of the bracket should be about 40mm (1.560mm (2-3/8") from the top of the tower.
[* red] Install the ''endstop switch bracket ''on the tower with the ''T-nut'' on the right side as you face the ''T-slot cover'' as shown. The top of the bracket should be about 40mm (1.560mm (2-3/8") from the top of the tower.
[* icon_note] Pass the ''wires'' under the ''switch bracket'' (in the ''T-slot'') and out the top as shown.
[* icon_note] You may have to "peal" the ''T-slot cover'' down a bit to make room for the ''switch bracket''.
[* icon_note] Do not over-tighten the ''M5x10 screw'', you will adjust the final position of the ''endstop switch bracket'' later.
[* red] Connect the'' endstop wires'' to the terminals on the ''switch''. Polarity doesn't matter but I like to wire all switches the same for, as the Shakers said "just for purdy."
[* red] Install the ''endstop switch brackets'' on the remaining two towers. The '''Z''' tower has an extra pair of wires for the ''LEDs'', these should also pass under the switch bracket and out the top as shown in the photo.

Image 2

Old Version

New Version

Image 3

Old Version

New Version