Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #35

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Installing the end stopsendstops
[* black] Installingred] Attach a ''T-nut'' with an ''M5x10 low profile socket head screw'' with the end stopscenter raised section of the ''T-nut'' facing as shown.
[* red] Install the ''endstop switch bracket ''on the tower with the ''T-nut'' on the right side as you face the ''T-slot cover'' as shown. The top of the bracket should be about 40mm (1.5") from the top of the tower.
[* icon_note] You may have to "peal" the ''T-slot cover'' down a bit to make room for the ''switch bracket''.
[* icon_note] Do not over-tighten the ''M5x10 screw'', you will adjust the final position of the ''endstop switch bracket'' later.
[* red] Connect the'' endstop wires'' to the terminals on the ''switch''. Polarity doesn't matter but I like to wire all switches the same for, as the Shakers said "just for purdy."
[* red] Install the'' endstop switch brackets'' on the remaining two towers.
[title] Installing the end stopsendstops
[* black] Installingred] Attach a ''T-nut'' with an ''M5x10 low profile socket head screw'' with the end stopscenter raised section of the ''T-nut'' facing as shown.
[* red] Install the ''endstop switch bracket ''on the tower with the ''T-nut'' on the right side as you face the ''T-slot cover'' as shown. The top of the bracket should be about 40mm (1.5") from the top of the tower.
[* icon_note] You may have to "peal" the ''T-slot cover'' down a bit to make room for the ''switch bracket''.
[* icon_note] Do not over-tighten the ''M5x10 screw'', you will adjust the final position of the ''endstop switch bracket'' later.
[* red] Connect the'' endstop wires'' to the terminals on the ''switch''. Polarity doesn't matter but I like to wire all switches the same for, as the Shakers said "just for purdy."
[* red] Install the'' endstop switch brackets'' on the remaining two towers.

Image 1

No previous image

Added

Image 2

No previous image

Added