Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #31

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Endstop wiring completion
[* red] Pull the ''endstop wire'' out of the bottom of the tower extrusion until the other end (white connectors) are about 40mm (1.5) shorter than the tower length as shown in the photo.
[* red] Insert one of the plastic channel ''covers'' you removed from the tower slots earlier. Insert the end about 1cm (1/2") into the corner extrusion.
[* red] Continue installing the ''cover'' in the slot until you reach near the top. Stop slightly below the connectors.
[* icon_note] Leave the ''cover'' extending beyond the top of the tower for now, we'll trim it to fit later.
[* red] Install the ''endstop wire'' in the '''bold text'''YY''' tower and install the cover in the same way.
[* blackred] Install the ''endstop wire'' in the '''Z''' tower but do++do not install the covercover++.
[* red] Install the ''endstop wire'' in the '''bold text'''YY''' tower and install the cover in the same way.
[* blackred] Install the ''endstop wire'' in the '''Z''' tower but do++do not install the covercover++.