Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #64

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install wiring management mount
[* red] TBDLocate the printed ''mast mount'', the two ''wire masts'' you saved from the previous ''Step'' and a ''low profile socket head ''screw.
[* red] Insert the long ''wire mast'' into the ''mast mount''. This might be a tight fit. If so, you can ream the hole with a 2.5mm drill bit or sharpen the end of the ''mast'' with a file and press it in.
[* red] Install the ''mast mount'' on the top of the cross member between the '''X''' and '''Z''' towers. There are three ''T-nuts'' in the slot, make sure to use the one closest to the '''X''' tower as shown in the second photo. Position the ''mast mount'' 75mm (3") from the end of the cross member extrusion as shown in the photo.
[* red] Install the shorter ''wire mast'' in the effector mast mount hole as shown in the third photo. You may have to ream the hole (2.5mm) or sharpen the end of the mast to get it to insert.
[* red] TBDLocate the printed ''mast mount'', the two ''wire masts'' you saved from the previous ''Step'' and a ''low profile socket head ''screw.
[* red] Insert the long ''wire mast'' into the ''mast mount''. This might be a tight fit. If so, you can ream the hole with a 2.5mm drill bit or sharpen the end of the ''mast'' with a file and press it in.
[* red] Install the ''mast mount'' on the top of the cross member between the '''X''' and '''Z''' towers. There are three ''T-nuts'' in the slot, make sure to use the one closest to the '''X''' tower as shown in the second photo. Position the ''mast mount'' 75mm (3") from the end of the cross member extrusion as shown in the photo.
[* red] Install the shorter ''wire mast'' in the effector mast mount hole as shown in the third photo. You may have to ream the hole (2.5mm) or sharpen the end of the mast to get it to insert.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added