Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #54

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Routing endstop wiring
[* red] Turn the D300VS upside down with the '''X''' tower to your right, the '''Y''' to your left and the '''Z''' tower in the rear.
[* icon_note] The endstop wires will be routed in the slots at the bottom of the lowest base cross members. This is easiest if you place the printer on the floor.
[* red] Cut three pieces of ''T-slot cover'' about ~180mm (7") long.
[* red] Start with the '''Z''' end stopendstop and LED wires. Route both pairs of wires down the ++right base cross member++ towards the X tower. Hold the wires in place with a piece of ''T-slot cover'' as shown in the first photo. The wires should exit the slot between the ''Duet'' mounting arms as shown.
[* red] Route the '''Y''' end stopendstop wires (on your left) from the '''Y''' tower ++towards++ the '''Z''' tower. Cover with a piece of ''T-slot cover''.
[* red] Route the '''X''' end stopendstop wires (on your right) from the '''X''' tower ++towards++ the '''Z''' tower. Cover with a piece of ''T-slot cover''.
[* red] Start with the '''Z''' end stopendstop and LED wires. Route both pairs of wires down the ++right base cross member++ towards the X tower. Hold the wires in place with a piece of ''T-slot cover'' as shown in the first photo. The wires should exit the slot between the ''Duet'' mounting arms as shown.
[* red] Route the '''Y''' end stopendstop wires (on your left) from the '''Y''' tower ++towards++ the '''Z''' tower. Cover with a piece of ''T-slot cover''.
[* red] Route the '''X''' end stopendstop wires (on your right) from the '''X''' tower ++towards++ the '''Z''' tower. Cover with a piece of ''T-slot cover''.