Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #56

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Connect the stepper motors
[* red] The connectors on the ''stepper motor'' wiring harness have two ridges on one side. We've highlighted those with black marker in the first photo. Use an X-acto knife to trim them off of the '''X''', '''Y''' and '''Z''' stepper connectors. Don't worry about routing the stepper harnesses neatly at this point, we'll do that later.
[* red] Connect the'' stepper motors'' to the ''Duet'' as shown in Photo 2the second photo.
[* red] Connect the'' stepper motors'' to the ''Duet'' as shown in Photo 2the second photo.
[* red] Start with the '''Z''' ''stepper motor'', then the '''Y''' and finally the '''X'''.
[* red] Make sure to orient the wires as shown with the blue wire on the right side of the connector.
[* icon_caution] Check your connections to the ''Duet'' to make sure the '''X''', '''Y''' and '''Z''' steppers are connected to the correct positions as shown in the second photo.