Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #57

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Connect LEDs and power supply
[* red] Connect the LED wring as shown in the first photo. This will be a temporary connection to test, we'll install the proper connection later.
[* red] Connect the LED wring as shown in the first photo. This will be a temporary connection to test, we'll install the proper connection later.
[* icon_note] Make sure to connect with the (+) terminal to the left and (-) to the right as shown in the photo.
[* icon_caution] Before proceeding make sure the power supply is not plugged in.
[* icon_caution] Unscrew the two terminal screws on the ''Duet'' out to fully open the terminal. The screws are captive so they will not come out of the terminal.
[*
red] Connect the power supply wires to the power terminalterminals as shown in the second photo. The black (-) wire connects to the position indicated with the black arrow and the positive (+) wire to the position indicated by the red arrow.
[* icon_caution] Make sure the wire ends insert into the opening. Gently tug on the wire after fastening to ensure it is connected properly.
[* icon_caution] Unscrew the two terminal screws on the ''Duet'' out to fully open the terminal. The screws are captive so they will not come out of the terminal.
[*
red] Connect the power supply wires to the power terminalterminals as shown in the second photo. The black (-) wire connects to the position indicated with the black arrow and the positive (+) wire to the position indicated by the red arrow.
[* icon_caution] Make sure the wire ends insert into the opening. Gently tug on the wire after fastening to ensure it is connected properly.
[* icon_caution] Double check the power supply connection to make sure the polarity is correct. Nasty things will happen if you reverse the wiring and turn on the power.